Long Agribusiness DTC250 won't start after PTO bind

[micali]

I was running the brush hog and I went over a tree that was a little too big and it bound up the blades and stopped everything. I thought it would have broke the sheer pin but it didn't. I immediately went to start it back up and there was nothing. No crank, no noise from the starter anything. I thought it was the negative ground and found it was loose. I replaced the negative cable and still nothing. I checked that the engine is not locked up. I got the tree out from the blades and spun the PTO shaft. I still don't have any crank. I do get power to the dash and to the PTO switch but nothing when I try and start it.

 

[TractorTech]

I don't know that tractor, but possibly could it have a PTO controller that isn't sensing that the PTO is off?

 

[micali]

That's my thought as well. The tag says LT 280D. The engine cover says 250 DTC.

 

[SatchmoIsBack]

Will it accept an analyzer? If so, see if you can clear any codes.

Just a WAG

 

[jfsawatzky]

Don’t know your tractor, but are there other safety cutoff features other than on the pto? For example, on the seat, gears, etc?