Lights on NH TC24D

[jwstewar]

I'll try to get some better pictures later. This is how I mounted the light on top of my ROPS. It is actually centered. I went with a single light as that would keep me within the amp rating of the aux. light wire that NH provided. Since I'm not the fabricator that most of you are I took the easy way and used 2"X2" square u-bolts from TSC, fit the ROPS perfectly.

 

[jwstewar]

This is a picture of the back worklight. This was a $10 cheapy from Wally World, but it mounted real secure and works great.

 

[jwstewar]

This is the wiring on back of the tractor going over to the rear worklight. You can also see the wire loom going up the side of the right fender up to the top light.

 

[jwstewar]

I mounted the switches on the plastic panel on the right fend by the 3PH controls and the 4WD selector. Everything is done with quick connect fittings so if something gets broken it won't be a big deal to swap out the broken piece. All in all probably 1 1/2 hours.

 

[Mrwurm]

Another job, well done /forums/images/graemlins/grin.gif

 

[JerryG]

Jim,
Looks good and should give you plenty of light. /forums/images/graemlins/smile.gif

 

[jwstewar]

Sorry guys forgot to bring the pictures w/ me yesterday so I can't do an edit now w/ the better pictures. Here is a picture looking at the front of the lights.

 

[jwstewar]

Another shot looking square on at the front.

 

[jwstewar]

A better shot of the switches.

 

[jwstewar]

Now you can actually see the wiring at the back of the tractor and how I had to run it up both of the fenders and underneath the mounting bracket for the seat - hey it was good enough for NH to do, good enough for me. /forums/images/graemlins/wink.gif