stumpster
New member
How dangerous is it to crank on this? There is a very slow leak and maybe if I can get a little bit of a turn on it I might stop it. I'm just worried about breaking something.
Leaking fitting on steel line
- Thread starter stumpster
- Start date
- Views: 2222
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
If you want to try tighten the fitting, use another wrench to hold the fitting tight and then slowly tighten the JIC nut.
Here is another fix for leaking fittings.
Excerpt:
Creates a perfect "Leak-Free" clip-on seal, Guaranteed!
Flaretite Seals - Clip the Drip!
Flaretite Seals - Clip the Drip!
Here is another fix for leaking fittings.
Excerpt:
Creates a perfect "Leak-Free" clip-on seal, Guaranteed!
Flaretite Seals - Clip the Drip!
Flaretite Seals - Clip the Drip!
Attachments
Winmac
Gold Member
- Joined
- Dec 31, 2011
- Messages
- 366
- Tractor
- Landini 6860
It appears to be a jic fitting, provided it's not over tightened already it won't hurt to give it a little more. My concern would be damaging the hard line from twisting, if there isn't any way to get a wrench on the tee.
wdchyd
Elite Member
Ya may wanna take it apart and make sure the connection at the flare is clean before you retighten
skyhook
Veteran Member
- Joined
- Mar 12, 2013
- Messages
- 1,906
- Location
- Canada Ontario
- Tractor
- 1996 Kubota L4200 GSTC,(sold) 1994 JCB 210S 4x4x4
The pipe appears to be off center with the fitting,
probably why it's leaking.
probably why it's leaking.
OP
stumpster
New member
So I finally got around to trying to fix the leak. I tried holding the T with a big wrench and tightening the fitting. I got about a quarter turn on it. It seems to have stopped leaking. Thanks for the suggestions.
I also had some problems with the 3rd function valve body this past weekend. This port was shooting oil over my shoulder. It was so lose it almost rattled. I think I got 2 full turns on it. That seems to be fixed now.
Later that same day oil started leaking from the screws that are exactly like these but on the other side of the valve. All 4 were lose. I have no clue what these do but I tightened them down as snug as I could get them. That leaking seems to have stopped now.
I also had some problems with the 3rd function valve body this past weekend. This port was shooting oil over my shoulder. It was so lose it almost rattled. I think I got 2 full turns on it. That seems to be fixed now.
Later that same day oil started leaking from the screws that are exactly like these but on the other side of the valve. All 4 were lose. I have no clue what these do but I tightened them down as snug as I could get them. That leaking seems to have stopped now.
