Land pride mower gearbox

   / Land pride mower gearbox #1  

MattM

New member
Joined
Oct 25, 2009
Messages
4
Location
Adirondacks, NY
Tractor
MF1533TLB and MF35
I just bought a used FDR 1672 finish mower. It looks like the gearbox mount platform is bent slightly, and the drive pulley is not quite aligned with the others. It's as if it were lifted by the gearbox shaft, so now the shaft isn't horizontal, it points up a little. The mount plate unbolts, and has a slot to slide the gearbox out with the pulley attached.
My question is Will the gearbox just unbolt and slide out? If the pulley stays on, are there any oil seals to mess with? Do you think a shop press could flatten the mount plate?
Thanks for any help.
 
   / Land pride mower gearbox #2  
I just had mine out for a painting job about a year ago. There isn't anything like seals to worry about. Just unbolt it and slide it out. I surely don't remember anything difficult about it and is pretty straightforward. Mine is an 84" but shouldn't really matter.
 
   / Land pride mower gearbox #3  
Don't make the job more complicated than its needs to be.

Shim the gearbox using washers to lift one side or tilt it front to back.

Mower decks often have to be shimmed to get the individual blade housing in correct alignment with the other blades.

jqvHRJl.jpg


Dave M7040
 
 

Tractor & Equipment Auctions

2017 JOHN DEERE 8270R LOT NUMBER 189 (A53084)
2017 JOHN DEERE...
UNVERFERTH 330 - 22-INCH EXTENTSION TUBE FOR BASE AND WING ASSEMBLY FOR RIPPER (A53472)
UNVERFERTH 330 -...
2012 JACK COUNTY 130BBL VACUUM TRAILER (A52472)
2012 JACK COUNTY...
2015 Peterbilt 320 Garbage Truck (A52377)
2015 Peterbilt 320...
2006 BOBCAT S130 SKID STEER (A52576)
2006 BOBCAT S130...
2020 JOHN DEERE 8R310 LOT NUMBER 210 (A53084)
2020 JOHN DEERE...
 
Top