L48 3pt linkage

[MtnViewRanch]

Does anyone know what L model or Grand L model would have the same 3pt hitch
linkage as an L48? :confused3:

 

[moship]

I don't directly know the answer to your question, but I downloaded the 3-pt drawings from Messicks.com. With the P/N's in hand you can check the other L-models to see what works. Good luck!

View attachment 3-POINT LINKAGE_DRAWBAR_HITCH.pdf

 

[MtnViewRanch]

Thanks, I ended up just getting the info off of the Kubota website. The only match up is an L4300.

 

[moship]

If you need to buy new check wholegoods price versus buying all the pieces individually. Wholegoods is typically through sales versus buying as parts... At least it use to be like this.

 

[MtnViewRanch]

If you need to buy new check wholegoods price versus buying all the pieces individually. Wholegoods is typically through sales versus buying as parts... At least it use to be like this.

Actually just checking to see if I already had the measurements to build a hydraulic side link for a customer. Not looking to purchase anything.

Thanks though.

 

[curtisfarmer]

I doubt the 4300 would match up. I have 2 L48s, the linkage uses a clevis pin to mount to the frame, which a 4300 does not have. Also, the arms are very thick, thicker than what I would expect on a non-industrial tractor. The hitch kits is ridiculously expensive if you have to buy after the fact. Good luck.

 

[MtnViewRanch]

I doubt the 4300 would match up. I have 2 L48s, the linkage uses a clevis pin to mount to the frame, which a 4300 does not have. Also, the arms are very thick, thicker than what I would expect on a non-industrial tractor. The hitch kits is ridiculously expensive if you have to buy after the fact. Good luck.

Not that it has ended up mattering, but according to Kubota, they use the same side link, part #32771-71540. That fits an L4300DT, an L4300F and an L48. That is straight off of the Kubota website.