OP
powerscol
Veteran Member
Well both units are sitting in my drive way. Need to read the operating manuals tonight and will test each tomorrow. So far everything looks good
Kuhn with tedder or Galfre
- Thread starter powerscol
- Start date
- Views: 11610
birddog0304
Silver Member
Congrats. Let us know how it goes. Don't forget pics.
OP
powerscol
Veteran Member
As requested. will try and fire up both tomorrow.
Farmer495
Veteran Member
Nice, looks like new!
OP
powerscol
Veteran Member
Both were in the rental fleet one season. The PZ 170 was out for only 8 days. The tedder was used roughly 16 times. All rentals were just for a day. Both were fully serviced before delivery
OP
powerscol
Veteran Member
PZ Test run was Sweeeeeeeeeeeeet. Cut is very clean, even it wet grass. I think I may want to get spacers to raise the height of cut (1") is a bit close. Tractor handled the weight easily, even in the rear transport position. No issues. I also have plenty of power. Still need to re-read the manual and learn the fine points of adjustment.
Tedder ran well too with no issues. It will take a few tries on adjusting so not to dig in. Once i find the settings I will write them on the unit.
Now the wait until next year to put them to use.
Over to TSC to get some winter tarps f0r storage.
Tedder ran well too with no issues. It will take a few tries on adjusting so not to dig in. Once i find the settings I will write them on the unit.
Now the wait until next year to put them to use.
Over to TSC to get some winter tarps f0r storage.
birddog0304
Silver Member
I used to think my disc mower cut too close. Unless u can set up spacers easily I would just try it out the way it is.
Those look nice. Good call in covering them up.
Those look nice. Good call in covering them up.
