We just completed changing the clutch on our Kabota tractor. We cannot get the tractor to start. It turns over just fine. I’ve pumped and pumped on the pump above the fuel filter. Filled the bulb up just fine with diesel fuel. That’s the end of it. Just don’t seem to getting any fuel to the injectors. With them bled and everything. Thanks, Lynn53
Kubota M8200 no start
- Thread starter Lynn53
- Start date
- Views: 3444
-
- Tags
- kubota m8200
5030
Rest in Peace
- Joined
- Feb 21, 2003
- Messages
- 28,967
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
If it's pre 4, there will be a small thumbwheel above the injection pump. You need to open that fully and then pump the knob on top the fuel filter to get the air out of the fuel lines. Once it starts leave the thumbwheel open to let the system purge all the air out. When it runs smooth, close the thunbwheel.
If it post 4 (common rail), call your dealer.
If it post 4 (common rail), call your dealer.
Hay Dude
Epic Contributor
- Joined
- Aug 28, 2012
- Messages
- 26,047
- Location
- A Hay Field along the PA/DE border
- Tractor
- Challenger MT655E, Massey Ferguson 7495, Challenger MT555D, Challenger MT535B Krone 4x4 XC baler, 2-Kubota ZD1211’s, 2020 Ram 5500 Cummins 4x4, IH 7500 4x4 dump truck, Kaufman 35’ tandem 19 ton trailer, Deere CX-15, Pottinger Hay mower, NH wheel rak
Were you getting fuel at the injectors with the lines cracked?
Kubota no start up date. When I would turn the key on all I was getting was a click sound. I finally got the tractor to start by jumping across the starter. That eliminated the air in the lines. I’ve put a new battery in & cleaned the battery to frame ground. Still just getting a clicking sound & to top that off. Pushed the clutch in to try & start tractor. Clutch remained on the floor.