Kubota M7040 Subframe for Snow Plow

[ctc1111]

I would like to mount a 8-10 foot plow straight to the frame of my M7040. It is for commercial use, so it would need to be a strong frame, perhaps going to the back of the tractor as I've seen before?

I'm even open to fabbing it myself if I could find some information on the proper way of doing this..

 

[PHILIP8N]

Here is part of the sub-frame for the GrandL. I attached at the front, sides, and drawbar (full frame). If I get a chance this week I will take pic of complete frame, as it is off the tractor now. Philip.

 

[slowzuki]

The guys who plow lots here with M's either use loader mounted plows or sub frame mounted plows. The subframe mounted units run to the rear drawbar and pin onto it or they connect to the rear axle with big u-bolts.

A smaller bracket up front keeps the plow aligned side to side and mounts the lift cylinder.

 

[PHILIP8N]

Here are pics of the GrandL sub-frame. It attaches with two 2" pins in front, two 1-1/4" pins mid-section, drawbar in rear. Philip.