Kubota B6100 hydraulics

DaveDitchfield · Jan 4, 2005

I have aadded a snow blade to the front of my b6100 and would appreciate any advice on hooking up the hydraulics. The original controls for a blower in the front were tapped into the distribution block on the right side beside the motor. This arrangement seemed to create a bypass problem for the 3 point hitch controls. I understadn that I can modify the distribution block to solve this problem.

I would appreciate any advice. Thanks

andrewimbrogno · Jan 4, 2005

Here is a link by tactor smart with all the instructions on how to mount my blade fo my b6100,
http://www.tractorsmart.com/Books/B2030.htm

If you need more help just post again.

DaveDitchfield · Jan 4, 2005

Thanks for this. I'm in Kingston, Ontario. Any other tips are appreciated!

ZackaryMac · Jan 4, 2005

Looks like there are a few of us on here with B6100's .
I adapted ATV snowplow to the front of mine. As crazy as that sounds, it fits rather well, and works great. I didn't measure it, but I believe it is a 4' blade. I used this setup, not only because it was readily available to me, and was in-expensive, but it has a manual lift, so I didn't have to bother with hydraulics, and if I remove 2 pins and one 1/4" bolt, I can back up and leave it there. It's heavy enough for the plowing I plan on doing.