Im trying to get the thermostat out of my 6403. The therostat housing at the end of the upper radiator hose is bolted to the block. Im assuming the thermostat is in their and it needs to be removed. However, there is a pressed in cooland line that is stuck in the housing. Any ideas how the housing is removed in order to get to the thermostat? Thanks in advance...
John Deere 6403 Thermostat
- Thread starter josh2500
- Start date
- Views: 2777
-
- Tags
- john deere 6403
pjbci
Platinum Member
- Joined
- Feb 10, 2012
- Messages
- 780
- Location
- Summit. Ms
- Tractor
- JD 4840, Deere 5075e, 450j, Cat D4k2, Kobelco 160, Volvo EC140el, deere 310, komatsu D31px22, IH 1486, MF 135, MHF TO35
That pressed in line will slip right out of the waterpump so im assuming it'll slip out of therm housing too. I know the waterpump end of it has a rubber grommet that allows for removal and reinstallation.
pjbci
Platinum Member
- Joined
- Feb 10, 2012
- Messages
- 780
- Location
- Summit. Ms
- Tractor
- JD 4840, Deere 5075e, 450j, Cat D4k2, Kobelco 160, Volvo EC140el, deere 310, komatsu D31px22, IH 1486, MF 135, MHF TO35
Yes. Just loosen it up out of retaining clips, then go ahead and take nuts off thermostat housing. Work it back n forth, should slide rite out. A thin film of grease should help sticking it back in. Dont use soap because it'll cause sudsing and bubbles in the system.
pjbci
Platinum Member
- Joined
- Feb 10, 2012
- Messages
- 780
- Location
- Summit. Ms
- Tractor
- JD 4840, Deere 5075e, 450j, Cat D4k2, Kobelco 160, Volvo EC140el, deere 310, komatsu D31px22, IH 1486, MF 135, MHF TO35
PS the rubber insert is internal where you cannot see it with pulling tubing.
buickanddeere
Super Member
A tractor that new having stat problems ?
