John Deere 467 Round Baler blowin seal on belt tension hyd. ram.

wbrowning · Aug 4, 2012

Standing looking a baler it is left side ram has no nicks it has blown 3 times it is attached to a 6310 could there be a restriction in block hyd. hoses attach to.

bigbull338 · Aug 5, 2012

wbrowning said:
Standing looking a baler it is left side ram has no nicks it has blown 3 times it is attached to a 6310 could there be a restriction in block hyd. hoses attach to.

do you have another tractor that you could run the baler on an see if it blows the seal again.if it blows again on a differant tractor then its the baler that has the prob.if it works fine then you have a prob on your baling tractor hydros that needs fixing.

Posm · Aug 9, 2012

Is it on the tailgate or the tension circuit?

Posm · Aug 9, 2012

Posm said:
Is it on the tailgate or the tension circuit?

I see it is the belt tension now. I am almost certain that the tailgate and belt tension circuits are isolated. The Deere uses small diameter, high pressure cylinders to run their density system. If you have properly installed more than one set of seals, you have a cylinder issue. It is scored, or out of round or you have a bur at a port. Take it to a cylinder shop who knows what they are doing and the will find the issue. I am sure that this is a Deere proprietary cylinder, so be prepared to pay up if replacement is needed. Should be ale to find a good used one on a burned baler at an Ag salvage yard.