JD 7775 skidsteer final drive bearings

Roscoe294 · Oct 21, 2012

The final drive on my John Deere 7775 skid steer is in need of a rebuild and I'm sure the others will soon follow. Does anyone know if JD or anyone else offer a kit consisting of the bearings, seals, shims etc.? Or do I need to buy by the piece from JD? Thanks

ctlguy · Oct 22, 2012

Can't speak for kits but you can price the parts through both a John Deere dealer and a New Holland dealer as this unit was NH built JD powered.

Tx Jim · Oct 22, 2012

I didn't see a kit but here's JD prices
8-JD9070 CONE, TAPER ROLLER BRG. ADD 17.25 USD 138.00 USD
8-AN231141 BEARING CUP ADD 8.51 USD 68.08 USD
4-AM1717T SEAL,OIL ADD 20.54 USD 82.16 USD
* Subtotal 288.24 USD

Roscoe294 · Oct 22, 2012

Just purchased one axle worth thru JD, everything minus the snap ring and a shim. $180 including tax. I will check with NH. LX665, correct?

art · Oct 23, 2012

Normally if one is there, take the time to check the others! We ahev found with Ag use they should be done between two for safeties sake and for sure by 3,000 hours for the least amount of parts.

ctlguy · Oct 24, 2012

Roscoe294 said:
Just purchased one axle worth thru JD, everything minus the snap ring and a shim. $180 including tax. I will check with NH. LX665, correct?

I believe that is correct.

Roscoe294 · Oct 26, 2012

art said:
Normally if one is there, take the time to check the others! We ahev found with Ag use they should be done between two for safeties sake and for sure by 3,000 hours for the least amount of parts.

Yeah, checked the others. The two rear are good, the other front will be done within the next couple months. Thanks.