hills
New member
Hi folks, I replaced the seal on the steering valve but when i replaced the unit i must have crossed up the lines. My bad. Does anyone know where I can see a drawing of the the connectons? John Deere is no help.
JD 4600 steering valve connection
- Thread starter hills
- Start date
- Views: 725
-
- Tags
- john deere 4600
Zebrafive
Super Member
Was the steering valve marked at the connections in any way that might help?
If you are not getting any steering I would swap the lines from the pump.
If it is steering right instead of left, I would swap the lines to the steering cylinder.
At least there are only four combinations.
If you are not getting any steering I would swap the lines from the pump.
If it is steering right instead of left, I would swap the lines to the steering cylinder.
At least there are only four combinations.