JD 146 Loader Control Valve

[JBF5]

Hello! I have a John Deere 2750 with 146 Loader that has started "drifting" more over the past couple years. Replaced o-rings in control valve but this didn't help. I suspect a new control valve is needed. My tractor has a cab with a joystick handle and cable attachments to the control valve located on the outside mid-right side of tractor (on loader frame). Has anyone changed the CV and found a substitute for the Cessna control valve that came on the 146 originally? I don't want to pay JD prices for a new part on a ~30 y/o tractor?

 

[mddorange]

:welcome:
To TBN JBF5 from Alabama. That sounds a little dangerous. Is it worse when lifting heavy loads?

 

[pmsmechanic]

It could also be the seals in the cylinders.

 

[Tx Jim]

It could also be the seals in the cylinders.

I agree boom cyl can be cause of boom settling if cyl rod seal is leaking & piston seal is also leaking internally. If boom cylinders are leaking past piston seals how can boom settle if no oil is exiting rod seal? Area for oil is less on rod side than on butt end of lift cyl on a 146. Any 2 spool closed center valve should work.

 

[J_J]

First find out if the valve is leaking or the cyl piston seals.

Maybe both.

How about this valve with Closed center plug.

2 SPOOL 25 GPM JOYSTICK LOADER CONTROL VALVE

CLOSED CENTER PLUG PRINCE RD5000 VALVES 660312005

 

[Tx Jim]

J_J
Would you recommend to run 6 hyd hoses into cab or can the valve you listed be converted to cable controlled?

 

[J_J]

Don't know for sure.

Would recommend calling Surplus for advice.

 

[JBF5]

The loader works fine. It only moves while "resting."

 

[JBF5]

There is no leaking of cyl seals externally. I swapped the hoses at the valve and the problem moved to the other cylinder- think that makes it a valve problem, right or wrong?

 

[J_J]

Sounds like you need a new valve.