I remember seeing a thread on this very subject but I can't find it. I want to flip my rear wheels to get a little more room for the draw bars and wanted to know the proper place to position the jack. Also any tips and/or advice is always welcome.
Jack Placement on a 2520
- Thread starter Piedmont
- Start date
- Views: 1609
Chris2520
Platinum Member
Put it right under where the draw bar slides into the rear houseing.
just dont go to far under. you dont want to jack on the trans houseing..
Chris.....
just dont go to far under. you dont want to jack on the trans houseing..
Chris.....
RoyJackson
Rest in Peace
- Joined
- Nov 17, 2001
- Messages
- 24,646
- Location
- Bethel, Vermont
- Tractor
- John Deere 4052R Cab,, Deere 855D UTV, Z920A Zero Turn Mower and assorted implements
Right on the Drawbar Bracket (bracket the draw bar slides in to) and don't forget to put jackstands under both axles.
Have a friend handy, especially if those tires are filled. Those extra hands can be a big help!
Some folks like to raise the tire high enough to use a jack under the tire (to help position it). I don't...I prefer to have the tire jacked just high enough to clear the floor. An eighth to a quarter inch is quite sufficient.
Have a friend handy, especially if those tires are filled. Those extra hands can be a big help!
Some folks like to raise the tire high enough to use a jack under the tire (to help position it). I don't...I prefer to have the tire jacked just high enough to clear the floor. An eighth to a quarter inch is quite sufficient.
Here are some similar links:
