Installing a return to tank line on a 4520 cab tractor

   / Installing a return to tank line on a 4520 cab tractor #1  

jenkinsph

Super Star Member
Joined
Feb 27, 2008
Messages
12,567
Location
somewhere usa
Tractor
Deere 110tlb, 4520, x749, L130
I am building up my laser grading system for the 4520 tractor and finally have all the electronics and other parts gathered up. The new two spool valve I have is a Danfoss PVG 32 proportional model which needs to keep the return line at a low pressure. I am looking for a good place to return to tank on the tractor without restrictions. Pressure flow is not a problem as I have three rear remotes to use.

Below is a picture of an access point I am considering using #30 is a 1/2" pipe plug. It appears to be below the oil level which will reduce air entrainment in the system. My thought is I could add a hose and coupler to this point for my return line. Any suggestions would be helpful.
 

Attachments

  • MP41279________UN29MAY08.gif
    MP41279________UN29MAY08.gif
    44.5 KB · Views: 120
   / Installing a return to tank line on a 4520 cab tractor #2  
As long as it is a true 1/2" plug (measures about 3/4" OD on the threads) then you should be good to go I would think. Half inch hose and couplers and you should be all set. :cool:
 
   / Installing a return to tank line on a 4520 cab tractor
  • Thread Starter
#3  
Thanks Brian, it is a 1/2" plug.

Anyone know what this plug and flange is for?
 
Last edited:

Tractor & Equipment Auctions

1994 Toyota 6000lbs 2 Stage Forklift (A51039)
1994 Toyota...
2007 WABASH 53FT DRY VAN TRAILER (A51222)
2007 WABASH 53FT...
2020 CATERPILLAR 259D3 SKID STEER (A51242)
2020 CATERPILLAR...
Kubota SVL95-2 High Flow Cab Skid Steer (A51039)
Kubota SVL95-2...
2012 MACK CHU613 (A50854)
2012 MACK CHU613...
2013 F-550 Bucket Truck (A51039)
2013 F-550 Bucket...
 
Top