marrt
Platinum Member
Power Trac mentions that the PT425 is made from 3/16” to 3/8” steel plate. Anyone know what gauge this would be? In other words, is there an approximate conversion from inches to gauge?
Inches to Gauge
- Thread starter marrt
- Start date
- Views: 1045
ronjhall
Super Star Member
marrt
<font color=blue>made from 3/16” to 3/8” steel plate. Anyone know what gauge this would be?</font color=blue>
I got my old Machinist’s handbook out to check on this. The thickest plate and sheet steel is 0000000 (7/0) which is .490”. These numbers are for US standard for plate. Check out <A target="_blank" HREF=http://www.constructionworknews.com/field-manual/2-3-0.html>this site</A> for list of all plate and wire gage sizes.
<font color=blue>made from 3/16” to 3/8” steel plate. Anyone know what gauge this would be?</font color=blue>
I got my old Machinist’s handbook out to check on this. The thickest plate and sheet steel is 0000000 (7/0) which is .490”. These numbers are for US standard for plate. Check out <A target="_blank" HREF=http://www.constructionworknews.com/field-manual/2-3-0.html>this site</A> for list of all plate and wire gage sizes.
PTRich
Gold Member
I would measure it as thicker than anything else out there.
PTRich
PTRich
MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 65,435
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
Roger that! You'll know how thick it is by the lump on your shin when you bump into it /w3tcompact/icons/laugh.gif .
