I'm Backkkk ! My old new 1425

[Marks481]

Well if you buy a new ROPS from PT, ask them if they can make it 2" taller. That makes it easier to add a suspension seat without smacking your head too many times...

 

[joshlee]

Look at that MR, now there's someone on here you can relate with (Kohler) :laughing:

So its a gas powered 1400 series? Neat!

 

[Barryh]

Yeah I read that about someone adding a suspension seat, plan on replacing mine also.... Used to bang my head on the PT-180 quite a bit, so I ended up padding it...

 

[MossRoad]

Look at that MR, now there's someone on here you can relate with (Kohler) :laughing:

Har har!! :laughing:

I love the machine. Don't like what I'm reading about the subees. If I had my druthers, I'd put in a clutch between the engine and hydraulic pumps. My guess is the subees would start fine with no load. :thumbsup:

 

[Barryh]

You bet :thumbsup:

 

[Barryh]

Can anyone give my the height of their Rop's on the 422 / 425 from the ground to the top. I will be ordering one in a few weeks and may ask them if they can make it a few inches taller per someones advice on here. I need to know that it won't top out going in and out on the garage door ..

Thanks

 

[Marks481]

About 68" from the ground to the front of the canopy.

 

[Barryh]

Thanks Tim ...

 

[Barryh]

Taking wheels off today to clean and inspect motors. I see a carter pin guessing there are wheel bearings of some sort in there ....Or not. Anyone know if there is a particular torque spec on the wheel nuts ?

 

[MossRoad]

No but I hear they're a bear to remove. Never took mine off. Maybe I'll regret that some day as they'll probably be frozen on.