D7E
Veteran Member
- Joined
- May 10, 2006
- Messages
- 2,251
- Location
- manitoba
- Tractor
- Versatile 895 Versatile 876 Ford TW20 Ford TW5 MF 3505 FWA MF 390 FWA Ford 7600 Fiat 766 FWA JD 2030 MF 165 MF 35 Fordson major x 3 CAT 416 b Backhoe Case 580 b backhoe MF
Replacing the o ring and shims in the top cover on the hydrostat pump...When i removed the top bearing it shifted to the side inside the casing...Only way i could re-install bearing was to remove inlet and outlet hyd lines and pry the servo's back through the holes while someone else installed the bearing and top cover from above.....Just wondering if there was a secret to this..!