Kubota B2710, IH TD6-62 dozer with Drott 4n1 bucket loader
You mean a top link that has 5/8" pin holes right?
Good luck. I don't think you will find any. Use a more common cat 1 link that has 7/8" pin hoses and use reducer bushings. TSC probably sells the bushings.
Kubota B2710, IH TD6-62 dozer with Drott 4n1 bucket loader
You mean a top link that has 5/8" pin holes right?
Good luck. I don't think you will find any. Use a more common cat 1 link that has 7/8" pin hoses and use reducer bushings. TSC probably sells the bushings.
After I sent that message I knew I messed up, it's a BX2230, but you knew that? The trouble is that the pin, center to center, closed can only be about 13". I seen one for Cat 0 at a Kubota dealer about a year before I bought this tractor. So I know they are out there, but just can't find them.
After I sent that message I knew I messed up, it's a BX2230, but you knew that? The trouble is that the pin, center to center, closed can only be about 13". I seen one for Cat 0 at a Kubota dealer about a year before I bought this tractor. So I know they are out there, but just can't find them.
Kubota B2710, IH TD6-62 dozer with Drott 4n1 bucket loader
The retracted length of the top link has nothing to due with the category 0 or 1 specification. The category specification deals with pin diameters and spacing between lift pins and top lin pin.
I am sure a BX2230 owner who has purchased a hydraulic toplink will chime in with where they got it. However, don't expect to get an exact match with respect to the retracted length.
Kubota B2710, IH TD6-62 dozer with Drott 4n1 bucket loader
The retracted length of the top link has nothing to due with the category 0 or 1 specification. The category specification deals with pin diameters and spacing between lift pins and top lin pin.
I am sure a BX2230 owner who has purchased a hydraulic toplink will chime in with where they got it. However, don't expect to get an exact match with respect to the retracted length.
