msingam
New member
Hi
I am interested in a complete hydraulic system for controlling a hydraulic motor as follows: To start, the motor will be free wheeling at around 300 rpm under very low load. This must be brought to stall condition with a holding torque of 15,000 Nm in about 40 - 120 seconds. Hold it continuously in stall for a long duration. Similar control is required while releasing and bringing to free wheeling. During stall, compensation for drifting from internal leakage, load changes etc. to be provided. Any suggestions on the hydraulic motor, the hydraulic circuit, component sizing and suppliers? Thanks
I am interested in a complete hydraulic system for controlling a hydraulic motor as follows: To start, the motor will be free wheeling at around 300 rpm under very low load. This must be brought to stall condition with a holding torque of 15,000 Nm in about 40 - 120 seconds. Hold it continuously in stall for a long duration. Similar control is required while releasing and bringing to free wheeling. During stall, compensation for drifting from internal leakage, load changes etc. to be provided. Any suggestions on the hydraulic motor, the hydraulic circuit, component sizing and suppliers? Thanks
