Hydraulic gauge install

[Gregster613]

Hi Marty, Thanks for that last info; I'm sure it will come in handy for me later. Although I don't think I have the aux harness on mine. No electrical wires under the seat that I recall. I'll have to search again. I'll find a fused hot wire somewhere, not too worried about that. Am more concerned with figuring out a switch that I can fit into my current joystick. I'll pop out the plastic diagram that's currently in place and hope to find a switch that fits to pop back in its place.

Anyway, here are some pictures of the valve, hoses, loader, etc. etc.
Pic (1) is valve, (2) is the KWANG fitting to be interchanged with, (3) shows my loader connects, (4 & 5) are my aux valves - Top&Tilt&spare, and (6) is feed from my pump - which is where I think I will install (eventually) a permanent gauge to monitor my system. I believe a Tee will work just fine there and it's not that difficult to get at. That's all just future thoughts at this time tho.
I hope this comes through okay. Haven't done this for quite a while. Greg

 

[Gregster613]

Hi Marty, My 7241-A QD's came last night. I only had time to give a quick check and "Yes" they fitted into the KWANG's nicely! I didn't run under pressure yet but am sure that as long as they completely connected together they will be fine. It looks like I will now have several spares on hand also. I will be able to complete my gauge and then begin focus on my step by step diverter install. Thanks Much for the right information that I needed. I will also post this in the hydraulic section since I originally asked for help there also.
Thanks a bunch! Greg