d1r1
New member
The hydraulic controller for the bucket is non-function. There is no resistance on the controller stick; front to back. side to side the stick works fine it curls and uncurls the bucket. What can be the problem?
Hydraulic controller for bucket is non functioning, will not raise or lower bucket.
- Thread starter d1r1
- Start date
- Views: 1144
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
Are you saying that the lever is sitting in neutral position and the lever will not move?
Are you saying that the lever will move fwd and rev and nothing happens?
Are you saying that the lever will move fwd and rev and nothing happens?
/ Hydraulic controller for bucket is non functioning, will not raise or lower bucket.
#3
deerseeker001
Super Member
- Joined
- Jul 20, 2011
- Messages
- 5,699
- Location
- Central wisconsin
- Tractor
- International 2500a with Loader
Welcome from Wisconsin
Tx Jim
New Member
Have you checked to be sure linkage is attached to spool?
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
Reset all the QD's.
Install a hyd gage and check the pressure.
Does the relief valve activate when you move the lever to full fwd or rev and hold it?
Can you see the spool moving in and out?
Remove the load check valve for the spool and inspect for damage. It mayn be in between the two work ports or on the backside of the valve.
Install a hyd gage and check the pressure.
Does the relief valve activate when you move the lever to full fwd or rev and hold it?
Can you see the spool moving in and out?
Remove the load check valve for the spool and inspect for damage. It mayn be in between the two work ports or on the backside of the valve.
