How to remove broken end of hydraulic orifice filter on a International 2424
- Thread starter Zebaz
- Start date
- Views: 1993
DJ54
Elite Member
- Joined
- Jan 20, 2009
- Messages
- 4,616
- Location
- Carroll, Ohio
- Tractor
- IH Farmall 656 gas/ IH 240 Utility/ 2, Super C Farmalls/ 2, Farmall A's/ Farmall BN/McCormick-Deering OS-6/McCormick-Deering O-4/ '36 Farmall F-12/ 480 Case hoe. '65 Ford 2000 3 cyl., 4 spd. w/3 spd Aux. Trans
Can you post a picture..??
DLTTrekkers
Veteran Member
Get a new one and start from there . o-ring removing tool with a bent tip ?
DJ54
Elite Member
- Joined
- Jan 20, 2009
- Messages
- 4,616
- Location
- Carroll, Ohio
- Tractor
- IH Farmall 656 gas/ IH 240 Utility/ 2, Super C Farmalls/ 2, Farmall A's/ Farmall BN/McCormick-Deering OS-6/McCormick-Deering O-4/ '36 Farmall F-12/ 480 Case hoe. '65 Ford 2000 3 cyl., 4 spd. w/3 spd Aux. Trans
If that groove is exposed, I'd make a tool out of a piece of 3/8" or larger rod, with, as mentioned a lip on the end to drop in it. Bend a piece of metal, or probably weld a piece of small angle iron on the end, to drop in that groove. Weld a piece on the outside end to tap with a hammer, outwards, rotating around it, as I tap. I have a slide hammer, with an end that would drop in there, if it weren't too long, similar to the two on the right in this picture. 
