Bootlegger750
Bronze Member
I grease mine about every 10 hours or so
How often do YOU grease your rotary cutter u-joints?
- Thread starter TBone
- Start date
- Views: 20417
DieselBound
Elite Member
If you pop off an end (assuming both ends were greased at the same time/interval) you can tell by rotating the yoke.
In general I try to remember to grease at about 10hr marks. Only a couple of zerks, so not a real big deal: but I'll do the other zerks on the cutter too (the tail wheel zerks are far away the ones that seem to always need grease the most/first).
In general I try to remember to grease at about 10hr marks. Only a couple of zerks, so not a real big deal: but I'll do the other zerks on the cutter too (the tail wheel zerks are far away the ones that seem to always need grease the most/first).
