Holes in loader

[dknarnd]

Would drilling into the large metal part just above the bucket harm the loader. I'm talking of the area where the standard hydrulic lines arre attached, I want to bolt an angle on there for my bulkhead fitting to the grapple. Probably only need 2 holes for bolts.

 

[farmacist]

Instead of drilling holes could you weld your bracket on or hold it in place with U bolts? good luck Frank

 

[smitty9266]

That is where the dealer put mine




Good luck

Jeff

 

[dknarnd]

Jeff,

Is that bulkhead bolted onto the loader in that location? This is where I was planning to install one on my loader.

 

[smitty9266]

yep the bulkhead that holds the QD pugs is bolted where you see it in the pic.
I also was bolted at the passenger side on that plate originally when I used the remote kit from New Holland, moved to the center when I purchased the elec over hyd kit from WR Long

Jeff