wolfden793
Silver Member
- Joined
- Nov 16, 2018
- Messages
- 108
- Location
- Lyndonville Vermont
- Tractor
- Deere LX 266, John Deere Gator TX, Kubota B7500, Takeuchi TB016
Hi All,
I was just honing the cylinder on a Tecumseh LEV 115 360021C engine, when I discovered a very small hole in the side of the cylinder wall on the side of the valves a little more than half way down. It has oil seeping from it and I'd never seen this before. No mention of this in the tech manual and wondered if it was some kind of pressure lubrication port? Obviously can't use until I know if this is normal or damaged. Thanks in advance for any info!
I was just honing the cylinder on a Tecumseh LEV 115 360021C engine, when I discovered a very small hole in the side of the cylinder wall on the side of the valves a little more than half way down. It has oil seeping from it and I'd never seen this before. No mention of this in the tech manual and wondered if it was some kind of pressure lubrication port? Obviously can't use until I know if this is normal or damaged. Thanks in advance for any info!