Hinomoto E182

[Tractors4u]

12 degrees was the overnight low here in North Alabama. This morning my FX26D didn't want to start. I pull one engine cover and set a small ceramic heater blowing on to the intake manifold and let it heat for about an hour and she finally started. My Ford Powerstoke was kind of ornry this morning too.

 

[RJB]

Well it warmed up today so I checked the E182 out a little closer. I have repaired gasoline powered equipment for 30 years , but I am just getting my feet wet on diesels. I discovered you can't check a glow plug with an ohm meter.
I pulled the glow plugs and found that both were bad. Thanks for all the input.
Rick

 

[gbirky]

It was 2 below 0 at my place in western MD Saturday morning. As with most of you - I didn't do any tractoring even though one was in the garage which was right around freezing.

Forcasters are calling for more of the really cold weather this week with lows in the single digits and highs only in the teens. We'll probably be below 0 a couple of nights at our place.

 

[kayssupply]

Would you give us some more details on not being able to check glow plugs with an ohm meter? This is something I have very little experience with and thought you could. FYI I have an NGK crossover catalog that has " some" that are the same as " some " Hinomotos.

 

[RJB]

I had check a couple of glow plugs that failed to show a continous circuit and proved to be bad. I figured that would mean a continous circuit would mean good (wrong). These showed a continous circuit and wouldn't heat. The Massey # for these glow plugs is 72097517 ( between $35 & $45 ). An NGK # would be great!

Thanks Rick

 

[kayssupply]

The later Hinomoto 1804 I had used a Y112TS NGK plug. The number was actually on the plug when I took it out. That number has a reference number 1232. I used a Y110 ref. 6825 and it fit that tractor. The 6825 lists for $9.92 and the 1232 / $16.16 from NGK . Go to glowplugs.com if you want to try one of these.

 

[RJB]

The E182 is a older 2cyl model and I'm not sure if they are the same as your 3cyl. I might have to try and locate one in somebody's stock and compare it.
Thanks Rick

 

[RJB]

I just wanted to update everyone on the E182. I put the new glow plugs in yesterday and it started right up. Thanks for all the replies and help.
Rick

 

[gbirky]

RJB,
For everybody's knowledge, which glow plugs did you end up getting?

 

[RJB]

Greg
The glow plugs were Y122 NGK (www.glowplugs.com). I think this # fits most of the 2cyl toyosha engines.

Thanks Rick