Hauling a bobcat

   / Hauling a bobcat #1  

Bvill01

New member
Joined
Mar 24, 2012
Messages
18
Location
Tx
Tractor
S220 bobcat loader
When hauling a bobcat how many binders and chains should I use and should I duck take the muffler?
 
   / Hauling a bobcat #2  
By the book says a 4 point tie down. Meaning a chain and binder @ each corner. Dont waste your time with the duct tape.
 
   / Hauling a bobcat #3  
when I used to haul heavy equipment out of the ports to the dealerships , we had to close off the exhaust on turbocharged machines to prevent air pressure from spinning the turbo with no oil flow.naturally aspirated machines we didnt worry about. 4 point tiedown is correct, the capacity of your tiedowns must be equal to or greater than the weight of your machine.

Hope this helps.

C-ya
Scott
 
   / Hauling a bobcat #4  
Chained at the 4 corners is described in the Operator Manual and required by most DOTs that I know of. No need to cover the exhaust, air pressure during transport can not force turbo to spin.
 
   / Hauling a bobcat
  • Thread Starter
#5  
In the front center and over the bucket or should I Ty the bucket separate ?
 
   / Hauling a bobcat #6  
With commercial trucking ,Texas ( my home state ) any and all attachments have to have their own tiedown , so yes the bucket by law would have to have a securment device on it as well ( even though its still attached to the machine ) LAWYERS !!!!! if I wasnt required to go into the scalehouses , ie pulling my own on my personal trailer, then no, I wouldnt worry about it.

I was taught to drive trucks on the farm, was told as long as the hand of GOD could reach down, pickup my trailer ,turn it upside down and I didnt loose my load, then I was doing ok :D

Hope this helps.
C-ya
Scott
 
   / Hauling a bobcat
  • Thread Starter
#7  
Thanks
 
   / Hauling a bobcat #8  
Take the Working Load Limit of each binder, divide by two, and then sum all of the binders. That must be equal to or greater than the weight of the machine. Minimum four binders.

On a rubber tired machine, you go to the nearest tie down that will triangulate the load. On a tracked machine, you go criss cross. Do not let the chains rub each other in this case.
 
   / Hauling a bobcat #9  
I was taught to drive trucks on the farm, was told as long as the hand of GOD could reach down, pickup my trailer ,turn it upside down and I didnt loose my load, then I was doing ok :D
Excellent tiedown strategy. Much better then the idiots I see running around with their Zeroturns, Bobcats, etc held in place with just the parking brake.

Aaron Z
 

Tractor & Equipment Auctions

2025 Mower King SSRC (A50123)
2025 Mower King...
2019 Caterpillar DP35N 7,000lb Diesel Forklift (A51691)
2019 Caterpillar...
2015 FREIGHTLINER CASCADIA TANDEM AXLE DAY CAB (A53426)
2015 FREIGHTLINER...
2018 KENWORTH T370 T/A DUMP TRUCK (A51406)
2018 KENWORTH T370...
ECHO SRM-2120 GAS WEED EATER (A51248)
ECHO SRM-2120 GAS...
UNUSED CFG INDUSTRIAL EXCAVATOR ATTACHMENT SET (A51248)
UNUSED CFG...
 
Top