greasing a 3016

[reeltime]

geased my 3016 today look under the tractor could not find any zerks to grease ligages exc am i missing any thanks ed

 

[burzynsr]

I am quite sure you are missing something.... Check the manual.

 

[reeltime]

I wish I had the manual just called dealer they are mailing me the manual today received BH and loader but not tractor manual my mistake for not checking paper work when I receive it thanks anyways

 

[johnsonauto]

If its an HST there should be 4 grease fittings(2 on each side)for the cross shafts for the pedals, one for the front axle pivot, the 2 tie rod ends and one on the steering cylinder end. Hope I am not forgetting something but think that gets all the ones on the tractor.
I would also recomend lubricating any of the linkage and moving parts that dont have fitting with some form of a sprak lube or white lithium spray.

 

[reeltime]

It's a shuttle I think I found them all checked every rolling and pivot point on the tractor up top and under loader and BH thanks

 

[johnsonauto]

Your welcome!

 

[reeltime]

Lower BH bucket pin no zerk on that pin is that mean missing or normal little hole in center this is BH 3720

 

[oldpilgrim]

I have zerks on every pin. You say you have a small hole? Should be a zerk in it.

 

[reeltime]

Will have to remove pin drill and tap a new one in just will call dealer to find out thread size so they are all the same

 

[rback33]

Look in the end of the dipper stick where the bucket is attached. There should be a zerk on the bushing that is greased from the end of the dipper stick.