Good morning!!!!

[Popgadget]

Good Morning
45 and overcast, high near 60 and rain likely later.

Yesterday I won my fight with the Mesh by a decision. I could not get the outdoor nodes to reliably stay connected with a wired backhaul, but the work fine with a wireless backhaul, which provides plenty of bandwidth for my application. So until I run out of projects to take up my time, it’s gonna stay wireless. Makes no sense, but I’ll take the win, even if it’s by decision.

I did get to the hangar and made significant progress on the little plane. Brought home a couple of small projects that I will attend to this morning, and then go back to the hangar.

Not much else planned, supposed to go to Palm Beach tomorrow and again on Tuesday, not sure how the ATC delays will impact us. I’ll have to do a little homework to see what’s up.

As I was typing this, a dense fog rolled in, visibility is about 100 feet.

 

[ArlyA]

Good morning tbn folks! One thermometer says its 9 here at camp Covington this morning while another says its 20. We are now thinking that lower thermometer is off since another and noaa says its 20. Got some snow overnight but not enough to write home about. Sun is now poking over the top of those snow covered pine trees. Hope everyone has a nice Sunday.

 

[m7040]

good morning, 51 going to 64, rain expected later on today

good day yesterday for wife, happy for her.

Worked a bit on the barn project and stacked a load of firewood

Today continue the barn project and wood stacking

 

[daugen]

on this day a few years back I had the leaf blower over at a friend's farm and was helping him with his leaves.

 

[kenmbz]

Morning all, 51 going to 63 and foggy, had a light rain yesterday, might be a bit more today.
Good having the kid home for a few days.

Got some more splitting done and stacked, another pile for the neighbor too.
Still need to aerate grass areas and rearrange garage for winter. It's been so warm that many of our flowers in pots are still around.
Still need to move the tractor plow to a better area.

Have to wait to move some of the garage around until leaves are dried out though.

Not sure what we will be up to today. We walked the dog at Peddlars yesterday, so she is in lazy mode now.

Be well,

3 big rounds quartered in vertical mode, then split in horizontal mode.

And off to the racks.

 

[daugen]

Ron, is it snowing at home?
looks like system coming here is bringing white stuff near Detroit

 

[daugen]

something strange happened last night.
at five minutes past midnight, my doorbell rings
and rings.
I get up, get shorts on, grab a high powered light to shine in some bad
guy's eyes and slowly open the door.
No one
door bell rings again
really???
so I push the button, it gives one last ring
and then shuts up.
geez, not that old maybe some dirt jammed it up like a stuck
keyboard key.
ghosts of Christmas past?

it's an rf device, wonder if something fooled it

 

[ronjhall]

Ron, is it snowing at home?
looks like system coming here is bringing white stuff near Detroit

It has been snowing all morning. But not sticking to drive and walkways yet.

 

[sodamo]

69°F and no rain 76% chance today

Had a really good mowing session for a few hours until I broke the mower. Not mower itself but the Shear Bolt Torque Limiter. Not usually a concern in the past, but this time it came completely apart losing the bearing inside. In the past, simply insert a 3/8 bolt and continue. Not this time, smaller, M8 shear bolt. Found a grade 5, but all thread. Lasted less than 100 ft. Suspect not having any bearings was a factor. End of mowing a couple hours shy of having that area done. Considered going to town and looking for better bolt but likely a waste of time. Will be calling Betstco first thing Monday

Probably a football watching day as it’s getting more overcast as I type.

Prayers for all
Be safe
Have a great tractor day

 

[WinterDeere]

on this day a few years back I had the leaf blower over at a friend's farm and was helping him with his leaves.
View attachment 4375354

Just finished a solid 2 days’ work with a rig not too dissimilar to that, starting a lunch time Friday and finishing at lunch time today (Sunday). I’ll try to remember to post a photo of my rig when I go back outside to take it apart after my lunch break.