Good morning!!!!

[Looking4new]

Good morning, the low is 32 and going to a high of 37°F. Wind SSE 6 mph. Flurries/rain all day.
There was some green grass showing here and there. Everything is all white again.

The only thing left to do before the Dodge goes to the shop is get the money out to pay for it. That'll be another grand gone.

Have a safe day all

 

[m7040]

Good morning, 48 going to 61 cooler today.

Going to PT this morning and going up to pick up parts in PA if the order is ready. Also picking up groceries and with 55 dollars off the bill the cost is down to what it used to be I think

Picked several loads of branches and sticks and took them out to the piles in the hinterland.
Also ran into a huge snapping turtle out of the pond. It looked mean.

Drew glad you are feeling better.

Buppies you are diligent about your care. Hope it goes well

 

[buckeyefarmer]

Buppies, hope they find something you can take. I know cipro makes me nauseous.
Ron, congratulations on long time on TBN.
Rip, Nice turtles, I’d leave that one alone too.
Pop, nice runway, don’t try to land the big plane there.

Hope all have a nice day. 54° sunny and windy here.
I have yet to venture to the creek with the mower, but not today.
Need to check out my big trailer, want to take BX23 to VA lot in a couple weeks to mow. I did put a new battery in it yesterday.

M7040, I’ll pick up parts tomorrow in PA, I’ll look for you. There’s a nice orchard store just north of there we like to go to. And we will get lunch near there.

 

[kenmbz]

Morning all, 48 going to 57, cloudy

Mostly good deal moving up in the ranks of racing

Wife's car, wheel cracked, $300 to replace :-(

not doing well today.

 

[riptides]

Hang in there Buppies. We are all sending our best for more positive outcome for you.

A news tidbit last night, seems the mRNA vaccines are showing promise against various melanomas.

There is always hope.

 

[buckeyefarmer]

Right side of mower lift arm is 3/4” lower than left side. That means shaft across is twisted, as everything is welded.
Then lift arm only goes down a little before right side of deck is all of way down, so it might be bent also, but need to remove the twist first before I can tell how much it is bent.
Blinkers on trailer work. Need someone else to check brake lights.

 

[LS Tractor Owner]

Good morning! Low of 44°, heading towards 72°. Very breezy already this morning, by this afternoon 15-25 mph. Then the fun will increase tomorrow with red flag warnings and gusts to 55. That will last through Thursday.

Buppies, hope you can get some good outcomes, prayers sent.

Drew, glad you are feeling better.

Mostly, congrats on moving up in the race stats.

Rip, beautiful pics of the turtle and property.

Paul, hope you get to try the new runway today.

Dennis, hope you can get the mower deck level. Good that you were able to get it started.

Ron, congrats on the TBN anniversary! Long time.....

Today's agenda is to batten down the hatches and prep for the wind. May re-price a project that got put on the back burner due to skyrocketing material prices. Probably save doing that for tomorrow ......while stuck inside.

Everyone have a great day!

 

[buckeyefarmer]

My part is in at Messicks so will run up there now, since I can make lunch at the diner.

 

[scootr]

Buckeye - Use a stick between the pedal and the seat bottom or ? to hold it down while you check lights.

 

[Engineer42]

Buckeye - Use a stick between the pedal and the seat bottom or ? to hold it down while you check lights.

A brick works also. Just depress the pedal a bit and lay the brick on top of pedal resting against the metal arm. Just enough to trip the switch.