Good morning!!!!

[mostly_gas]

Good evening all. 28F this morning temps have been easing down all day 17F last check. 6F, and up to an inch of snow tonight, dusting so far. Cold through Tuesday then warming last half of the week.

 

[Larro Darro]

Good Evening. 2035, clear, 51F with 87% humidity. Forecast low of 43F tonight, and a high of 71F tomorrow. Another really nice day here at the Larro Ranchero. I spent all morning online, and still tilled the garden, washed both cars, pruned the grape vines and went for a walk with Margie. There is no telling what I could have got done if I hadn't wasted away half the day

I'm hoping the ice and cold stays well to our north. Our forecast low for Thursday is 37F, but I trust Buppies more than Wunderground.

Larro

My mind completely erased the truck battery episode. I measured the new one in the store, and it looked to be the same size as the old one. But I found out it was about an eighth of an inch wider. And the clamp that holds it down fit the old one exactly. And I mean exactly. So my choices were to break one of the brackets off the clamp, or try to bend it a little. I was able to bend it enough using a crescent wrench that it would at least start to go over the edge. Then all I could do was tighten it as much as it would allow.

So then I figure it was just putting on the new positive terminal {the old one broke when I took it off} clamping it down, and I would be done. But then I found out the holes on the two cable clamps I had to put on the new terminal were just a hair too small to fit over the bolt. The only rat-tail file I could find was the one I use to sharpen the chain on my saw, so I used it to enlarge the hole. After a few minutes, and not much progress I thought of my cordless drill. After I put the file in the drill, the job went much faster. So a five minute job took about thirty five. Situation normal........

Larro

 

[300UGUY]

My mind completely erased the truck battery episode. I measured the new one in the store, and it looked to be the same size as the old one. But I found out it was about an eighth of an inch wider. And the clamp that holds it down fit the old one exactly. And I mean exactly. So my choices were to break one of the brackets off the clamp, or try to bend it a little. I was able to bend it enough using a crescent wrench that it would at least start to go over the edge. Then all I could do was tighten it as much as it would allow.

So then I figure it was just putting on the new positive terminal {the old one broke when I took it off} clamping it down, and I would be done. But then I found out the holes on the two cable clamps I had to put on the new terminal were just a hair too small to fit over the bolt. The only rat-tail file I could find was the one I use to sharpen the chain on my saw, so I used it to enlarge the hole. After a few minutes, and not much progress I thought of my cordless drill. After I put the file in the drill, the job went much faster. So a five minute job took about thirty five. Situation normal........

Larro

Lucky! That point is where I usually break something!

 

[jmurray01]

Good mornin' folks!!

I have had just about enough caffeine to make me feel something close to human so with that I'd better get off to work and consume more caffeine there to maybe even be productive!

The reason I haven't been posting here for a long time is that, due to the housing situation, I have had no time or motivation to do anything other than work. It hasn't been great, but I mustn't dwell as there are others in far worse places than I.

Right, I really need to go so I'll leave this post to a quick greeting and come back later to read through all the posts I missed whilst "away".

Take care guys.

 

[RoyJackson]

2014-02-10, 0340

11 degrees right now, high of 23 predicted...

Monday, back to the grind...

 

[Thomas]

15F half inch snow fell last night,temps topping off low 30's w/clearing.

Like Roy said.."Monday, back to the grind..."

 

[Buppies]

Monday-morning quarterback here snow coming our friends in NC to get hammered with snow ice sleet. This will be a good size storm with 1 to 2 in rain at 10 to 1 is a pretty good snow then up the coast to New England. 30 degrees this morning chance of light snow high 38 later today. Whatever preparations that need to be made for this storm should be made especially us in the south. Good morning

 

[wngsprd]

31F this morning. As much as I like snow, I'm not sure I want what you are predicting, Buppies.

 

[daugen]

over an inch of snow for us last night, enough to have to go out and clean up.
Off to the pain doc early for my last neck epidural; boy I love docs who are on time, know their stuff,
and use twilight which is a marvelous anesthesia, but not for Michael Jackson. The won't let me drive so my
faithful friend Bill will be here in half an hour and he knows the drill. He drops me off, goes to Lowes for an hour, and then picks me up and we go
off to breakfast.

boy, I'm getting a little tired of this.
more shrub wrecking weather.

Thursday's forecast, so far...
Periods of snow during the morning will transition to a wintry mix in the afternoon. High 37F. Winds NNE at 10 to 20 mph.
Chance of precip 90%. Snow and ice accumulating 5 to 8 inches.

 

[dave1949]

10*F, calm and overcast. 1/2" of snow last night. Just a couple inches forecast for Thursday as of now.

Guess I will check out some more health insurance w/Medicare stuff today.