Good morning!!!!

   / Good morning!!!! #178,572  
For a while I saw ads for Summit tractors here when I logged on.
Now ads for Bad Boy tractors. Made by same South Korean company that makes Branson.
I think they use a Cummins diesel. ??
Bad Boy makes good zero turns and has been amazingly successful.
They built a million square foot plant in Arkansas and are now retailing a compact tractor.
Seems like an American success story.

Those Bulldog tractors were widespread for awhile, lots on youtube on old tractor videos,
mostly Europe. If you can forget about the pollution, two stroke brings a lot of simplicity and reliability with it.

need to try the automatic parking
I have that on Volvo, both entering and leaving.
never pushed the button.
with 360 cameras, parking is a lot easier, plus not that much parallel parking
in this area.
 
   / Good morning!!!! #178,573  
good morning 48 going to 64

Picking up groceries this morning. Need to clean off patio area for berries and leaves also lots of chestnut and walnuts to clean up

Mostly yes repairing the tractors. Was sent into the field at the farmers at times to repair. Learned to scrape bearings. Only one rod bearing.

Here is short video of how to start a Lanz Bulldog

 
   / Good morning!!!! #178,574  
Drew, front tires on a MH tend to run cooler because of rear overhang of a Class C. This takes weight off front tires. I have never seen a crowd at truck stop weigh scales. Escapee’s in Bushnell, FL has a setup to weigh each tire/set of tires on a RV. Not sure your November trip takes you near there.
 
   / Good morning!!!! #178,576  
Up early today. Getting some work done in preparation for going to the eye doctor again this AM. They will do some serious analyzing on the next eye for cataract removal and lens implant in November after I return from FL to celebrate Mom's 100th birthday. Her secret to a long life might be religion and red wine. ;)
Live long and prosper everybody.
happy 100 to your mom.
 
   / Good morning!!!! #178,577  
Morning all, 44 going up to 66 and cloudy. 1/2" rain last night.

Got one more panel up and a few more strips, now need to finish the strips and measure out for the next panel order. Probably half way through, but the rest are multiple cuts and weird shapes.

Thomas-hope updated knee surgery fixes issue, can't come fast enough for you I'm sure

Be well,
 
   / Good morning!!!! #178,579  

Attachments

  • WLD_1800.JPG
    WLD_1800.JPG
    675.3 KB · Views: 92

Tractor & Equipment Auctions

2014 Dodge Ram 5500 4x4 Bucket Truck with Altec AT40M - 45FT Boom, Jib Winch and Utility Bed (A52748)
2014 Dodge Ram...
2-Row Peanut Inverter (Chain Drive, PTO, 3-Point Hitch) (A52748)
2-Row Peanut...
Genie GTH-644 (A50490)
Genie GTH-644 (A50490)
2019 KENWORTH T680 TANDEM AXLE SLEEPER (A52576)
2019 KENWORTH T680...
2017 TRAILSTART 40FT DUMP TRAILER (A52576)
2017 TRAILSTART...
UNVERFERTH 330 - 19-INCH EXTENSION KIT FOR RIP-STRIP TOOLBAR PART # 63186G (A52748)
UNVERFERTH 330 -...
 
Top