BTackett
Gold Member
I am in the process of semi-restoring a Mitsubishi MT372 and before removing the wiring harness the glow plugs were working fine. I installed a new ignition switch ( 5 prong w/preheat Kubota ) and it would turn over but not glow plug. So, I put the old switch back on that worked before ( reason I replaced was that it was sticking in the run position, preheat worked fine ) and it turns over but no preheat now. What could be wrong? I just removed one wire on the glow plug itself. Now preheat will not work.
Any ideas?
I checked my wiring diagram and it shows a 4 prong switch but it was wired 5 prong previously and worked fine.
How exactly do glow plugs work and how can you check them at the switch with meter?
What actually causes the dash indicator to glow when preheating?
Help
Thanks,
Bill
Any ideas?
I checked my wiring diagram and it shows a 4 prong switch but it was wired 5 prong previously and worked fine.
How exactly do glow plugs work and how can you check them at the switch with meter?
What actually causes the dash indicator to glow when preheating?
Help
Thanks,
Bill
