GL5240 HST, Error-92, Motor NG ??

[JerryJHarrison]

Hoping to revive this conversation. I have a Kubota L5740 and yesterday while moving some light brush, the red warning indicator began to flash, and the Intel-Panel began to display the Error - 92, Motor NG described above. I also was limited to the lower range, so I suspect the advise so far in this article is spot on. Can anyone tell me where the hi-Lo Solenoid is located on the L5740? I have looked near both hydraulic filters, but so far nothing jumps out at me as a solenoid.

Thanks,

Jerry Harrison
2007 L5740 HST

 

[JerryJHarrison]

OK, found it. Left hand side of the tractor near the hydraulic filter. One single strand wire running into it, and this wire was broken about 8 inches before the connector to the Solenoid. Soldered the wire back together, insulated the connection, and replaced it into the wire conduit, and strapped it all back together.

No more error code.