gabem1

[gabem1]

I just got a 2009 s 250 . happened to have a local bobcat road tech looking at another 250 he checked codes a said all looks good ,put it to work that day ran a plainner no problems the second day ran for a few hours and got a acs8103 code and could not move the plainner left or right .Got it back to the shop did some basic checks battery 7-way conector that runs the attachments all pins were ok. then the machine now works fine only ran for half hour.Does anyone have any sugjestions.
Thanks Gabe

 

[brain55]

I have limited experience with a planer, but had a similar problem with the planer we used. I ended up tracing the harness from the planer to the machine and found a chafed wire that was causing the problem.

Good luck,
Brian