fx235 power shift trans install

[agreen]

is there any kind of trick to get the power shift portion of the trans(front block of trans with the clutch packs) to meet up with front half of tractor? i cannot seem to get this to line up. i can get the back half of trans with the pinion gear, to meet up with the power shift section but cant get the power shift section to meet up with tractor.. i need some kind of advice im at a loss.

 

[winston1]

I may not even be on the same page so just remember I am old and sensitive. Are you talking about the main drive shaft that goes through the clutch assembly? Similiar to #23 in this parts drawing? Yanmar Tractor Parts: CLUTCH Any dowel pins to line up? Splines need turning to line up? Any pictures? Never have seen a parts drawing or pictures of your model so I'm just rambling thinking it might help the thought process. :thumbsup: