fordblue32
New member
Good thing i checked the fuel in the tank.Fuel guage is stuck in the full position.Any suggestions on what to look for to get the guage to work properly.I certainly dont want to run out of fuel.Thanks!Tc24da
Fuel gauge always reads full.
- Thread starter fordblue32
- Start date
- Views: 11308
ovrszd
Epic Contributor
- Joined
- May 27, 2006
- Messages
- 33,724
- Location
- Missouri
- Tractor
- Kubota M9540, Ford 3910FWD, Ford 555A, JD2210
Welcome to TBN.
You'll get some good responses to this question. We have some very handy people here.
My Ford 3910 has the same problem. I'm thinking it's the sender unit but haven't took the time to disassemble the tractor to find out. I removed my dash cluster and made sure my wiring to the gauge and sender unit is intact.
You'll get some good responses to this question. We have some very handy people here.
My Ford 3910 has the same problem. I'm thinking it's the sender unit but haven't took the time to disassemble the tractor to find out. I removed my dash cluster and made sure my wiring to the gauge and sender unit is intact.
OP
fordblue32
New member
I will take the dash apart and look around and clean things up.
Leejohn
Elite Member
Unhook the + from the sending unit, if gauge drops it's the sending unit. If you just touch the + to ground, the gauge should pop to full. Do not leave it there just touch it quick.