Frontend noise

   / Frontend noise #1  

Straphanger

New member
Joined
Aug 24, 2023
Messages
4
Tractor
Kubota BX 2670
My BX 2670 has a clicking noise in the left front wheel sometimes. Think it could be a wheel bearing?
 
   / Frontend noise #2  
Could be. Could be a lot of other things too. Not much information to try to help.

Have you lifted the front end up and hand spun it? Happen with 4WD engaged and not? Does it happen when turning the wheels? Etc
 
   / Frontend noise
  • Thread Starter
#3  
It does it in 2 or 4 wheel drive. I did jack it up and spin the wheels--no noise. When I drive it I can hear it, mostly when turning.
 
   / Frontend noise #4  
Have you checked the lugs for tightness? May be some slop which shows up mainly while turning. Not sure what the hub assembly is like but might needs some snugging up there?
 
   / Frontend noise
  • Thread Starter
#5  
Have you checked the lugs for tightness? May be some slop which shows up mainly while turning. Not sure what the hub assembly is like but might needs some snugging up there?
The lugs are tight. I even took off the wheel to make sure there was nothing jammed in there.
 
  • Good Post
Reactions: JWR
   / Frontend noise #6  
Front u-joint going bad makes a clicking noise but I would always say it's on the right front. Easy to change.
 
   / Frontend noise
  • Thread Starter
#7  
It sounds like a u-joint but is on the left front. I think I'll pull the shaft and check it. Does it come out easy?
 
   / Frontend noise #8  
Just pull the boot (cover) to check. If you need it off jack the front of the tractor let the axle pivot down on the shaft side. Then 2 pins (may be doubled roll pins that need some force) after that there should be enough room to remove the joint. Used be $50 or so part from Kubota.
 
   / Frontend noise #9  
Just pull the boot (cover) to check. If you need it off jack the front of the tractor let the axle pivot down on the shaft side. Then 2 pins (may be doubled roll pins that need some force) after that there should be enough room to remove the joint. Used be $50 or so part from Kubota.
Also make sure the axle is not low/out of oil, the tend to leak a bit with age.
 
   / Frontend noise #10  
Occasional clicking is not a reason to start pulling u-joints apart! I'd give this a lot more time and watching before doing anything rash.
 

Tractor & Equipment Auctions

2010 KENWORTH T270 SERVICE TRUCK (A51243)
2010 KENWORTH T270...
2018 Club Car Carryall 500 Electric Utility Cart (A51691)
2018 Club Car...
2012 Ford F350 Bucket Truck (A47384)
2012 Ford F350...
(INOP) 2007 INTERNATIONAL 4200 SBA 4X2 DUMP TRUCK (A51243)
(INOP) 2007...
2011 JOHN DEERE 310SJ BACKHOE (A51242)
2011 JOHN DEERE...
2007 JOHN DEERE 624J WHEEL LOADER (A51406)
2007 JOHN DEERE...
 
Top