Front mount snowblower
- Thread starter tjmcd
- Start date
- Views: 1200
art
Super Member
It could with the right subframes but it is about 40 lbs heavier then the one from the factory. /forums/images/graemlins/shocked.gif That unit normally fits the standard B-series. /forums/images/graemlins/blush.gif
sandyc
Veteran Member
I have a 2200 that has a BX2750 snowblower. The blower mounts to the front end via a qucik connect system that has three main components. The quick mount connects to the front end of the tractor as well as has the hydraulic cylinder to raise and lower the blower. There is a drive shaft that then connects the mid pto with the front quick connect. The blower has a shaft that then connects to the quick mount. Looks a bit Rube Goldberg but works great!
I don't think weight is a problem as much as getting the power to the blower and being able to raise and lower it. Don't forget to look how you are going to rotate the shoot . Mine has a manual crank that runs very close to my fourway valve. ( you'll need to use the FEL valve to power the raising and lowering of the unit)
Confused?
I don't think weight is a problem as much as getting the power to the blower and being able to raise and lower it. Don't forget to look how you are going to rotate the shoot . Mine has a manual crank that runs very close to my fourway valve. ( you'll need to use the FEL valve to power the raising and lowering of the unit)
Confused?
