somanytractors
Silver Member
I have a 9n thats been sitting so long that it had 5 stuck valves in it.
One was so bad I had to pull the guide with the valve in it, and then work the valve out of the guide.
The gasket set I got for it has rubber seals that look like they might go in the groove on the guide but there was no seal on the guide when I pulled it.
Is this supposed to have seals in the grooves or are they for another model?
Any help would be greatly appreciated.
Thanks
John
One was so bad I had to pull the guide with the valve in it, and then work the valve out of the guide.
The gasket set I got for it has rubber seals that look like they might go in the groove on the guide but there was no seal on the guide when I pulled it.
Is this supposed to have seals in the grooves or are they for another model?
Any help would be greatly appreciated.
Thanks
John
