I recently replaced the PTO shaft seal on my Ford 2000 3cyl.gas tractor. The 3 Pt.was working fine before I replaced the seal.After replacing the seal and refilling the rear end with Hyd.fluid , when I try to prime the Hyd. Pump with the tractor idling, there is no fluid coming out of the pump at the bleed screw. Thanks for any help!
Texasmark
Elite Member
- Joined
- Apr 24, 2012
- Messages
- 3,703
- Location
- N. Texas
- Tractor
- Ford: '88 3910 Series II, '80 3600, '65 3000; '07 6530C Branson with FEL, 2020 LS MT225S. Case-IH 395 and 895 with cab. All Diesels
Maybe the pump is a bit worn and doesn't suck as good as a new one. I'd suggest you up the RPMs to get better suction and have the 3 pt lift lever in the down position....if that matters....won't hurt.