I have a 1986 Ford 1210 with around 950 hours. Earlier this spring while the tractor was idling engine started pumping out of the breather tube. Long story short, found the seal on the output shaft of the hydraulic pump that mounts to the engine went bad. Replaced the seal put everything back together, used it for about an hour moving mulch around. While idling again the same thing happened, the seal had moved forward. Took the pump apart to inspect it and could not find anything. Reassembled everything and the same thing has happened third a time. Could the pump be going bad or could something cause the system to over pressure and blow the seal out? I am going to test the PSI once I have it back together again. Any input would be greatly appreciated. I have gone through the manual but don’t have a real answer that would cause it.
sandman2234
Super Member
- Joined
- Dec 4, 2005
- Messages
- 6,110
- Location
- Jacksonville, Florida
- Tractor
- JD2555 and a few Allis Chalmers and now one Kubota
I have a recently acquired 1210, but have no idea what could be causing your problem!
Does yours have a belly mower on it? Where are you located?
David from jax
Does yours have a belly mower on it? Where are you located?
David from jax
wdchyd
Elite Member
If the seal is getting pushed out then you have too much wear in the pump housing, gear set and wear (thrust) plate. Time for new internal worn parts or a new pump (which is cheaper most times)
