fittings leak

[Dirtnut]

yes it is a prince. you can get it with this type of pull handle or with a long stem handle that makes it 90 degrees to the valve. my dealer is trying to get them in a smaller size so they dont take up so much room.

 

[KiotiJohn]

Dirtnut, I'm heart broken. You mean my instructions were of no help? /forums/images/graemlins/grin.gif John

 

[Dirtnut]

sorry didnt mean to break your heart /forums/images/graemlins/frown.gif all information i got was greatly appreciated and is now on file for future reference. hope the information i posted will help fellow TBNrs in the future WHAT A GREAT SITE /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif /forums/images/graemlins/grin.gif THANKS AGAIN TO ALL.

 

[Jim_in_Omaha]

Anyone find a good source for those washers? I found some at NAPA but they are 9/16 ID. I have not taken the valve body apart yet to get and exact measurement of the male fitting. Can't find any 11/16. Otherwise if you have some Jon, I'll have to buy them from you for the valve kit I got from you last year. There is a one more store here locally that I am going to check when I find time.

thx
Jim

 

[Jim_in_Omaha]

I found some copper washers at a Caterpillar shop. Their part number is 2A-1162. ID is .639" and OD is 1". They were tight on the fitting and almost too wide for the recess in the valve body. But they seem to work so far.
thx
Jim