Fencing question

   / Fencing question #1  

Barnbuilder

Gold Member
Joined
Apr 21, 2009
Messages
397
Location
Waxhaw, NC
Tractor
Bobcat A300, Kubota F3680, JCB 212S sold
Have a friend that wants me to put up some fence for a pregnant cow he purchased for is daughter. I've put up fence for horses for a long time but not a cow. I was going to use the 2"x4" woven no climb wire like the rest of the fence I built for him. 5" round posts to support it. I've seen people spread the posts out before like 15'-20' on center. The person I spoke to at the supply house said no more than 12'. You guys have any suggestions or experience?

For the horse fence I put 4"x4"s on 7' centers and a 2"x6" on top to prevent the horses from riding the wire down.
 
   / Fencing question #2  
For cattle I go 10' on center and ran a strand of barb wire6" higher than the woven fence
 
   / Fencing question #3  
We use electrified and 10 to 15 between. They only have to touch it once or twice.
 
   / Fencing question
  • Thread Starter
#4  
Yea he doesn't want to use hot wire. He has a couple goats and sheep also.
 
   / Fencing question #5  
Like Streetcar, we went 10', and a strand of barb on top for cattle. If he has goats, he'll want a strand of electric about mid-shoulder high to the goats. When they shed, they will lean on the fence, and start walking. Not sure how high off the ground you plan on putting it, but once again with goats, if they can get their head under it, they will get down on their knee's, and reach for grass on the other side, and eventually bow/stretch the bottom out. The plus side of not having a low strand to prevent this, is the only place you need to trim, is in front of the post on the outside of the fence, where they can't reach.
 
   / Fencing question #6  
For woven wire, I did wood posts every 100 ft (or change in elevation) with t posts every 8-10 ft
 
   / Fencing question
  • Thread Starter
#7  
I put the woven down on the ground so nothing can get under it. I don't think he realized how expensive his present was going to be. Not sure I'll get started tomorrow. It rained most of last night and half of today. Thanks for your help. Need a post driver.
 
   / Fencing question #8  
t-post every 12 feet, wood post every 10 t-posts, barbed wire along the bottom and an inch off the top.
 
   / Fencing question #9  
Goats will tear themselves up on barbed wire, they never stop testing fences. A strand of electric is good to keep them from climbing on the woven wire. Otherwise they'll wear it out. If you really don't to use electric you need to use either no-climb horse fence or cattle panels if you want it to last with goats.
 
   / Fencing question #10  
I have 1 1/2 miles of five strand barbed wire fencing around my property. I set 133 heavy duty T-posts on 13 foot centers. Has been up and operational - with minimum repairs - for 34 years. The only "wooden" posts I've used are those treated gooey real railroad ties.
 

Tractor & Equipment Auctions

2019 CATERPILLAR 262D3 SKID STEER (A52705)
2019 CATERPILLAR...
2004 Ford F-250 4x4 Service Truck with Liftgate (A55788)
2004 Ford F-250...
2017 PETERBILT 579 TANDEM AXLE SLEEPER (A54313)
2017 PETERBILT 579...
2012 Club Car Carryall 1 Utility Cart (A54811)
2012 Club Car...
2018 CATERPILLAR 745 OFF ROAD DUMP TRUCK (A52705)
2018 CATERPILLAR...
BUNDLE OF 82" X 49" DIAMOND PLATE SHEET METAL (A54756)
BUNDLE OF 82" X...
 
Top