Everlast Welders - Welders and Plasma Cutters by Everlast

[lilranch2001]

Why do you think they just hired a billion new IRS Agents?!?!???

 

[yomax4]

I'm hoping a new administration creates a billion new unemployed IRS agents.

 

[Mark @ Everlast]

Just got back from the International Work Boat Show in New Orleans. Couldn't spend any green except for tipping...and even once that was only available by some "app".

 

[ArlyA]

I have the cyclone 212es and when I'm welding with power set feature, but I'm getting about 3" of wire after I've taken my finger off the wire button. Kinda drives me nuts and of course there is a chance I changed some setting by accident. I do want it to quit as soon as I stop pressing the wire trigger. You guys know how to stop this extra feed?

 

[ArlyA]

I have the cyclone 212es and when I'm welding with power set feature, but I'm getting about 3" of wire after I've taken my finger off the wire button. Kinda drives me nuts and of course there is a chance I changed some setting by accident. I do want it to quit as soon as I stop pressing the wire trigger. You guys know how to stop this extra feed?

da! I'll call them.
------------------------------------------------------------

• Local. 650 588 8082. ext: 204.
• email: performance@everlastwelders.com.
• Operating Hours: Monday through Friday: 9AM to 5PM PST.

 

[Mark @ Everlast]

I have the cyclone 212es and when I'm welding with power set feature, but I'm getting about 3" of wire after I've taken my finger off the wire button. Kinda drives me nuts and of course there is a chance I changed some setting by accident. I do want it to quit as soon as I stop pressing the wire trigger. You guys know how to stop this extra feed?

Are you running it in 4T mode?

 

[ArlyA]

Are you running it in 4T mode?

I might be! How do I get it out of that mode?

 

[Mark @ Everlast]

Select 2T on the trigger tab. Make sure you select the "std." torch.

 

[ArlyA]

Select 2T on the trigger tab. Make sure you select the "std." torch.

thanks!!

 

[ArlyA]

Finally got this welder in use. Where should I post reports on it?