engine swap on poulan pro

   / engine swap on poulan pro #1  

genso

New member
Joined
Jun 3, 2014
Messages
1
Location
evansville
Tractor
poulan
What a great help this forum is to we uninformed diy'ers...I'm working on a swapped 18 hp flathead, opposed twin, 42a707 briggs engine that I replaced my poulan pro 22 hp vanguard with...I have rebuilt carb, removed gas tank and cleaned out and replaced fuel line. new plugs and fuel filter. It will start and run at idle but when I raise the rpms rapidly it dies. It will restart with choke and runs if I very slowly increase the speed even to wide open. It has the carb mounted fuel pump and it seems there is real good flow. I have not yet hooked up the alternator wiring cause I'm still not sure how to do it on this mower cause the original had a regulator and this engine doesn't. Someone said I could just connect it to the battery positive wiring but I'd like to continue using my key ignition and not do the toggle switch stuff. Question is; could the wire not being in the loop be the problem ?
 

Tractor & Equipment Auctions

2012 Cadillac CTS Sedan (A53424)
2012 Cadillac CTS...
Anderson 31ft T/A Flatbed Equipment Trailer (A51691)
Anderson 31ft T/A...
HAMM 3205 SMOOTH DRUM ROLLER (A51242)
HAMM 3205 SMOOTH...
2012 Freightliner M2 106 Asphalt Pothole Patcher Truck (A54814)
2012 Freightliner...
Landoll Hauloll (A53473)
Landoll Hauloll...
2015 Ford F-350 Cab and Chassis Truck (A53422)
2015 Ford F-350...
 
Top