Engcon tilt/rotator arrived:)
- Thread starter Fixastuff
- Start date
- Views: 2423
Seven Gables
Platinum Member
- Joined
- Jan 30, 2019
- Messages
- 607
- Location
- Northern lower Michigan
- Tractor
- jd 5115m , Ford 545D, Kubota M8540, NH t4.105 , Ford 5030, Ford 4830, NH TN 95FA, Volvo EC60E
That engcon tilt rotator looks like a really slick and useful tool. Will it pin to you’re stick and bucket cylinder or does it come with a topside quick hitch? If not too much trouble keep us informed on how the whole set up goes together, looks like quite a lot to it.
I plan to pin it on. Finally got the machine side of the bucket quick coupler circuit figured out and ordered. Maybe I can be tilting and rotating in a week or two.
Rustyiron
Super Member
Are you rotating and tilting yet?
The controls are deeply integrated into the machine and I wish you the best on getting this together.
The guys in Europe I think have been using these for years (I think
) and following a couple of them on YouTube..... it's artistry!
A buddy had Cat put one on his mini and I've played with it. I could see many hours of seat time before I could be considered an "operator "!
The controls are deeply integrated into the machine and I wish you the best on getting this together.
The guys in Europe I think have been using these for years (I think
) and following a couple of them on YouTube..... it's artistry!A buddy had Cat put one on his mini and I've played with it. I could see many hours of seat time before I could be considered an "operator "!
I haven’t got it on the machine yet. The spacers/ears/bosses whatever you want to call them were to narrow for my stick. I had a machine shop press them out machine .25” off the face of each and press them back in. The mushroomed them up and now I can’t get pins in.
Worst part is it’s a shop I use often and so while they should fix it I’m not sure I want to go that route. I wish they would have called me to let me know they were struggling before they destroyed them.
