Desperate need of 1620 Ford New Holland clutch input shaft

[Bennernikki]

Hello,
We need input shaft that goes into the spines on the clutch disc and turns the transmission gears for our tractor. Cannot find it anywhere. Any help or ideas would be greatly appreciated. THANKS!!

 

[DJ54]

Here's a list of 6 in salvage yards, although one appears to be a hydro. https://www.tractorhouse.com/listings/dismantled-machines/ford/1620/farm-equipment

Hopefully one will have what you need.

 

[ROUSTABOUT]

You can't clean it up with a die grinder and sand paper? What happened to ruin it? I run and work on lots of junk. I've never seen a bad input shaft. Last one I took out was a 41 model WW2 truck I got off an oilfield company.

 

[Bennernikki]

Here's a list of 6 in salvage yards, although one appears to be a hydro. https://www.tractorhouse.com/listings/dismantled-machines/ford/1620/farm-equipment

Hopefully one will have what you need.

THANK YOU so very much.

 

[Bennernikki]

You can't clean it up with a die grinder and sand paper? What happened to ruin it? I run and work on lots of junk. I've never seen a bad input shaft. Last one I took out was a 41 model WW2 truck I got off an oilfield company.

Hi, I am not sure what happened to it. We left it at our rental house for our tenant to use until we needed it. Well.... big mistake. We were on our way with trailer from Knoxville to Indiana to pick up when they told us it wouldn't go forward or in reverse. AGGH. We took to a New Holland shop. They split the engine and told us the tractor was junk and we owed them 1,200. Shop said part were obsolete and we need to buy a new tractor. They must think I am "from the city". Hahaha.
Oh.. they have had the tractor since July. Never called us about it and couldn't even find it when I called for information. Great place.....

 

[DJ54]

THANK YOU so very much.

Welcome...